← Ferramentas 📚

Prateleira Simples

Prateleira básica versátil · Boxes.py local

⇓ SVG ⇓ DXF
Encaixe (Finger Joint)
Estilo dos dentes
Espaço nas extremidades
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
Largura dos dentes
Folga para encaixe
Espaço entre dentes
width of finger holes (multiples of thickness)
Empilhável
inside angle of the feet
height of strips to be glued to the inside of bottom edges (multiples of thickness)
height of the feet (multiples of thickness)
distance from finger holes to bottom edge (multiples of thickness)
width of the feet (multiples of thickness)
Dobradiça
have lid overlap at the sides (similar to OutSetEdge)
set to lower value to get disks surrounding the pins
diameter of the pin hole (multiples of thickness)
fixed length of the grips on he lids (multiples of thickness)
thickness of the arc holding the pin in place (multiples of thickness)
Dobradiça de Gabinete
diameter of the pin hole in mm
pieces per hinge
number of hinges per edge
style of hinge used
radius of the eye (multiples of thickness)
space between eyes (multiples of thickness)
minimum space around the hinge (multiples of thickness)
Tampa
width of the "finger hole" in mm
additional pin for better positioning
position(s) of the extra locking springs in the lid
Estilo dos dentes
Espaço nas extremidades
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
Largura dos dentes
Folga para encaixe
Espaço entre dentes
width of finger holes (multiples of thickness)
angle of the hooks bending outward
radius at the bottom (multiples of thickness)
length of the hooks (multiples of thickness)
for RoundedTriangleEdge
height above the wall
radius of hole
radius of top corner
extend the triangle along the length of the edge (multiples of thickness)
Montagem
head diameter of mounting screw (in mm)
shaft diameter of mounting screw (in mm)
minimum space left and right without holes (fraction of the edge length)
number of mounting holes (integer)
side of box (not all valid configurations make sense...)
edge style
for HandleEdge
height above the wall in mm
height of hole(s) in percentage of maximum hole height (handle height - 2 * material thickness)
width of hole(s) in percentage of maximum hole width (width of edge - (n+1) * material thickness)
added to side panels if checked, to front and back otherwise (only used with top_edge parameter)
radius of corners in mm
extend the handle along the length of the edge (multiples of thickness)
StorageShelf
Largura interna
sections back to front in mm 🛈
sections bottom to top in mm 🛈
Usar medidas externas
edge type for bottom edge
edge type for top edge
height of retaining wall at the front edges
use finger hole edge for retainer walls
Configurações Padrão
Espessura do material
Compensação de queima/kerf
label the parts (where available)
Estilo cantos internos
Espaçamento entre peças
⇓ Baixar SVG ⇓ Baixar DXF
⚙ Gerando peças...
📚 Configure os parâmetros e clique em Gerar
para ver as peças para corte laser.