← Ferramentas ⊞

Bandeja Gridfinity

Insertes para Gridfinity · Boxes.py local

⇓ SVG ⇓ DXF
Encaixe (Finger Joint)
Estilo dos dentes
Espaço nas extremidades
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
Largura dos dentes
Folga para encaixe
Espaço entre dentes
width of finger holes (multiples of thickness)
Tampa
Tipo de alça
Tipo de tampa
Altura da alça
Altura da aba
play when sliding the lid on in multiples of thickness (if applicable)
GridfinityTrayLayout
height in mm or add 'u' at the end for Gridfinity units
Altura interna
number of gridfinity grids in X direction
number of gridfinity grids in Y direction
split x into this many grid sections. 0 means same as --nx
split y into this many grid sections. 0 means same as --ny
Leave this much total margin on the outside, in mm
support gridfinity compatible stacking
generate pads to be used on the bottom of the box
The corner radius for each grid opening. Typical is 0.8,
if pads are cut add holes for magnets. Typical is 6.5, zero to disable,
if magnet hole offset from pitch corners. Typical is 7.75.
the thickness of base the box will sit upon. 0 to use the material thickness, 4.65 for a standard Gridfinity 3D printed
Configurações Padrão
Espessura do material
Compensação de queima/kerf
label the parts (where available)
Estilo cantos internos
Espaçamento entre peças
⇓ Baixar SVG ⇓ Baixar DXF
⚙ Gerando peças...
⊞ Configure os parâmetros e clique em Gerar
para ver as peças para corte laser.