← Ferramentas ⊞

Caixa Brocas Gridfinity

Brocas no Gridfinity · Boxes.py local

⇓ SVG ⇓ DXF
Encaixe (Finger Joint)
Estilo dos dentes
Espaço nas extremidades
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
Largura dos dentes
Folga para encaixe
Espaço entre dentes
width of finger holes (multiples of thickness)
for RoundedTriangleEdge
height above the wall
radius of hole
radius of top corner
extend the triangle along the length of the edge (multiples of thickness)
Empilhável
inside angle of the feet
height of strips to be glued to the inside of bottom edges (multiples of thickness)
height of the feet (multiples of thickness)
distance from finger holes to bottom edge (multiples of thickness)
width of the feet (multiples of thickness)
Montagem
head diameter of mounting screw (in mm)
shaft diameter of mounting screw (in mm)
minimum space left and right without holes (fraction of the edge length)
number of mounting holes (integer)
side of box (not all valid configurations make sense...)
edge style
Tampa
Tipo de alça
Tipo de tampa
Altura da alça
Altura da aba
play when sliding the lid on in multiples of thickness (if applicable)
GridfinityDrillBox
number of gridfinity grids in X direction
number of gridfinity grids in Y direction
Leave this much total margin on the outside, in mm
edge type for top edge
sections bottom to top in mm 🛈
Configurações Padrão
Espessura do material
Compensação de queima/kerf
label the parts (where available)
Estilo cantos internos
Espaçamento entre peças
⇓ Baixar SVG ⇓ Baixar DXF
⚙ Gerando peças...
⊞ Configure os parâmetros e clique em Gerar
para ver as peças para corte laser.