← Ferramentas ⊞

Base Gridfinity

Sistema modular Gridfinity · Boxes.py local

⇓ SVG ⇓ DXF
Dove Tail Joints
how much should fingers widen (-80 to 80)
how far the dove tails stick out of/into the edge (multiples of thickness)
radius used on all four corners (multiples of thickness)
from one middle of a dove tail to another (multiples of thickness)
Encaixe (Finger Joint)
Estilo dos dentes
Espaço nas extremidades
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
Largura dos dentes
Folga para encaixe
Espaço entre dentes
width of finger holes (multiples of thickness)
Tampa
Tipo de alça
Tipo de tampa
Altura da alça
Altura da aba
play when sliding the lid on in multiples of thickness (if applicable)
GridfinityBase
size of base in X direction (0=auto)
size of base in Y direction (0=auto)
number of grids in X direction (0=auto)
number of grids in Y direction (0=auto)
height of sidewalls of the tray (mm)
Extra margin around the gridfinity base to allow it to drop into the carrier (mm)
edge type for bottom edge
edge type for sub panels
The Gridfinity pitch, in mm. Should always be 42.
The cutout for each grid opening. Typical is 38.
The corner radius for each grid opening. Typical is 1.6.
cut pads to be used for gridinity boxes from the grid openings
if pads are cut add holes for magnets. Typical is 6.5, zero to disable,
if magnet hole offset from pitch corners. Typical is 7.75.
The corner radius for each grid opening. Typical is 0.8,
the maximum sized panel that can be cut in x direction
the maximum sized panel that can be cut in y direction
Configurações Padrão
Espessura do material
Compensação de queima/kerf
label the parts (where available)
Estilo cantos internos
Espaçamento entre peças
⇓ Baixar SVG ⇓ Baixar DXF
⚙ Gerando peças...
⊞ Configure os parâmetros e clique em Gerar
para ver as peças para corte laser.