← Ferramentas
🐦
Dispenser Bola Pássaro
Bolinhas de gordura para pássaros · Boxes.py local
▶ Gerar
⇓ SVG
⇓ DXF
FatBallDispenser
Sides
Número de lados
Pole diameter
The diameter of the poles.
Ball diameter
The diameter of the fat balls. Give some extra mm to make it a loose fit
Balcony width
The width of the area outside of the poles.
Balcony height
The height of the balcony in mm. Set to 0 if no walls are needed.
Drain hole diameter
The diameter of the hole of the floor (to drain rainwater) in mm. Set to 0 if you don't need it.
Pole clearance
The minimum distance between a pole and the central refill hole in the ceiling in mm.
Slide clearance
The gap between the parts that slide into each other in the locking mechanism in mm.
Spacer width
The width of the spacer (part of the locking mechanism) in mm.
Pole clearance factor
The fraction of the pole clearance which is being used for the locking mechanism.
Roof overhang
Defines how much wider than the bottom floor the roof is.
Roof height
The height of the roof in mm.
Roof hole diameter
The diameter of the hole of the roof in mm. Set to 0 if you don't want to attach a hanger.
Roof maintenance clearance
The distance from on bottom corner of the roof to the maintenance hole in mm.
Roof support fraction
The radius of the roof support part as a fraction of the roof radius.
Configurações Padrão
Espessura do material (mm)
Espessura do material
Kerf / Burn (mm)
Compensação de queima/kerf
Rótulos
label the parts (where available)
Cantos internos
loop
corner
backarc
Estilo cantos internos
Espaçamento (mm)
Espaçamento entre peças
▶ Gerar peças
⇓ Baixar SVG
⇓ Baixar DXF
⚙ Gerando peças...
🐦
Configure os parâmetros e clique em
Gerar
para ver as peças para corte laser.