← Ferramentas
🖼️
Moldura para Gravação
Para artes e gravações laser · Boxes.py local
▶ Gerar
⇓ SVG
⇓ DXF
Encaixe (Finger Joint)
Estilo do encaixe
rectangular
springs
barbs
snap
Estilo dos dentes
Espaço nas extremidades
Espaço nas extremidades
Lábio inferior
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
Largura da borda
space below holes of FingerHoleEdge (multiples of thickness)
Comprimento extra
extra material to grind away burn marks (multiples of thickness)
Largura do dente
Largura dos dentes
Folga do encaixe
Folga para encaixe
Espaço entre dentes
Espaço entre dentes
Largura do furo
width of finger holes (multiples of thickness)
EngravingFrame
Engravingwidth
width of the visible part of the engraving in mm
Engravingheight
height of the visible part of the engraving in mm
Engravingthickness
thickness of the engraving plate (and any acrylic window you may add) in mm
Margin
margin for the engraving plate insertion in mm
Framethickness
width of the frame in mm
Frameoutercornersradius
radius of the frame outer corners in mm
Frameinnercornersradius
radius of the frame inner corners in mm
Addcoveringfrontplate
Add a covenring front plate to glue (hiding the finger joints)
Adddummyfingers
Add dummy finger holes and plugs for the unity of the frame (if not covered)
Backsupportangle
angle of the back support in degrees ; set 0 or negative value to ignore
Configurações Padrão
Espessura do material (mm)
Espessura do material
Kerf / Burn (mm)
Compensação de queima/kerf
Rótulos
label the parts (where available)
Cantos internos
loop
corner
backarc
Estilo cantos internos
Espaçamento (mm)
Espaçamento entre peças
▶ Gerar peças
⇓ Baixar SVG
⇓ Baixar DXF
⚙ Gerando peças...
🖼️
Configure os parâmetros e clique em
Gerar
para ver as peças para corte laser.