← Ferramentas 🗂️

Bandeja com Divisórias

Divisórias configuráveis · Boxes.py local

⇓ SVG ⇓ DXF
Encaixe (Finger Joint)
Estilo dos dentes
Espaço nas extremidades
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
Largura dos dentes
Folga para encaixe
Espaço entre dentes
width of finger holes (multiples of thickness)
for HandleEdge
height above the wall in mm
height of hole(s) in percentage of maximum hole height (handle height - 2 * material thickness)
width of hole(s) in percentage of maximum hole width (width of edge - (n+1) * material thickness)
added to side panels if checked, to front and back otherwise (only used with top_edge parameter)
radius of corners in mm
extend the handle along the length of the edge (multiples of thickness)
Tampa
Tipo de alça
Tipo de tampa
Altura da alça
Altura da aba
play when sliding the lid on in multiples of thickness (if applicable)
for Divider Slots
angle at which slots are generated, in degrees. 0° is vertical.
depth of the slot in mm
extra slack (in addition to thickness and kerf) to help insert dividers in mm
radius of the slot entrance in mm
Notches on the Dividers
for Dividers
margin between box's bottom and divider's in mm
play to avoid them clamping onto the walls (in multiples of thickness)
DividerTray
sections left to right in mm 🛈
sections back to front in mm 🛈
Altura interna
Usar medidas externas
generate the same notches on the walls that are on the dividers
generate wall on the left side
generate wall on the right side
generate wall on the bottom
add handle to the bottom
Configurações Padrão
Espessura do material
Compensação de queima/kerf
label the parts (where available)
Estilo cantos internos
Espaçamento entre peças
⇓ Baixar SVG ⇓ Baixar DXF
⚙ Gerando peças...
🗂️ Configure os parâmetros e clique em Gerar
para ver as peças para corte laser.